Paradigmia
⌕Sign in ↗
Lessons

Muscle contraction

Created by: Javier Sáez Hurtado

The stimulation that muscle receives through the motor nerve fibres will generate a muscle action potential, which once triggered will spread along the whole membrane or sarcolemma. This electrical excitation at the membrane level will translate into a mechanical response called muscle contraction.

Muscle contraction occurs through the sliding of the thick and thin filaments past each other. This interdigitation of the filaments produces a decrease in the length of the sarcomere. During sarcomere shortening, the Z discs or lines move closer to each other.

The sliding filament model proposes that the thin filaments move over the thick ones. This displacement is possible through the binding between the myosin heads and the active or complementary sites of the actin molecule.

The formation of bonds, through cross-bridges, between actin and myosin, which are cyclically activated and deactivated, is the process that leads to muscle shortening during contraction.

1. Cyclic mechanism of formation and removal of cross-bridges

This cyclic activity can be divided into at least four stages:

1.1 Formation of the actomyosin complex

When the muscle is at rest, the myosin head is bound to ADP+Pi but has not yet bound to actin (myosin is said to be charged). When the myosin head forms a complex with actin (actomyosin), contraction proper begins.

1.2 Release of (ADP + Pi) + conformational change

Once the actomyosin complex has formed, ADP and Pi are rapidly released from the myosin head, the myosin head itself undergoes a conformational change, and it bends, forming an angle of 45º with the actin.

1.3 ATP binding and hydrolysis

After the displacement, the bond between the two molecules is strong and both filaments remain attached. For them to separate, ATP must bind to the myosin head and the ATP must be hydrolysed.

1.4 Release of (ADP + Pi) + conformational change

The energy released by the rapid hydrolysis of ATP returns the myosin head to its original position. A single cycle displaces the thin filament by about 10 nm; at sarcomere level the shortening is 1 µ; and the force developed is 5. 10-12 N.

As there are millions of asynchronous cycles, the force and the shortening are very great. The cycles can be repeated as long as neither the shortening capacity of the sarcomere nor the ATP runs out. If the latter occurs, the bridges cannot break and the cycle stops with the filaments bound together, or with rigid cross-bridges.

The asynchronous, repetitive activity of formation and disappearance of cross-bridges ensures that the force exerted by the thick filaments on the thin ones is maintained during contraction.


2. Role of Ca++ in the regulation of actin-myosin bonds

Troponin C has four binding sites for Ca++: two of high affinity, which bind Ca++ and Mg++, and two of low affinity, which bind Ca exclusively. Activation of troponin C changes the position of the troponin complex and of tropomyosin, which shifts slightly and leaves free the site on actin to which myosin binds; the myosin will attach to the actin, forming the actomyosin complex, the cross-bridges.

The role of switch attributed to Ca++ in this mechanism is due to the ease with which it can pass from the active or “on” state to the inactive or “off” state. This is because of the extraordinary speed with which the Ca++ concentration can vary at the level of the myofilaments.

In relaxed muscle the concentration is very low; at the moment of activation it can increase up to 1000-fold, which allows the maximum number of cross-bridges to form.


3.Excitation-contraction coupling

The role of Ca++ in the formation of cross-bridges, as well as the need for its removal, was discussed in the previous section.

Cellular excitation, of which the action potential is a manifestation, spreads rapidly through the cell membrane, an important part of which is the complex system of T tubules, in close contact with the sarcoplasmic reticulum, at the level of the triads.

The membrane of the T tubules and that of the cisternae of the sarcoplasmic reticulum contain integral membrane proteins that function as channel proteins, allowing Ca++ to pass from their respective fluid spaces into the cytosol. In this way the electrical signal (the order to contract) located in the fibre membrane becomes a chemical signal (Ca++) in the cell cytoplasm.

Your study

Select a passage in the lesson. Your highlights are private.

0Back to course →
Keep exploring

Knowledge does not end here.

Paradigmia · YouTube ↗